Electronics 578-24 Manuale Utente Scaricare il pdf

ELECTRONICS INCORPORATED

SHOT PEENING TECHNOLOGY

MODEL 578-24 MagnaValve

www.electronics-inc.com

578-24data.pub 5/18/09

999290

The Model 578-24 MagnaValve is a normally closed magnetic valve suitable for

regulation of steel shot and includes a built-in sensor for accurate measurement of flow

rate. Used with the Model FC-24 Shot Flow Controller, the MagnaValve will provide

accurate and repeatable flow rates over a 6 - 30 pounds-per-minute flow range. The

578-24 MagnaValve can be re-calibrated for various shot types and sizes for higher

accuracy.

The valve construction includes a permanent magnet for normally closed operation

and an electromagnet for controlling shot flow rates. By regulating the voltage to the

electromagnet, any desired flow rate may be achieved. When power is off, the valve

will hold shot due to the permanent magnet.

The Model 578-24 MagnaValve incorporates a preamplifier circuit to allow for high

noise immunity and a 0-10 Vdc output. The valve is factory calibrated and results are

included upon request. Note: consult factory for pre-calibration using media other than

cast steel shot.

• High Accuracy - ±5% of FS

• Built-in flow sensor

• 6 - 30 lbs/min range

• Normally closed

• Requires FC - 24 Flow Controller

• Air type shot peening machines

• Variable flow rates

• No moving parts

• Steel shot or Steel grit

• With 6’ Cable

1 2

ELECTRONICS INCORPORATED SHOT PEENING TECHNOLOGY MODEL 578-24 MagnaValve www.electronics-inc.com 578-24data.pub 5/18/09 999290 The Model 578-24 Magna

56790 Magnetic Drive, Mishawaka, IN, USA 46545 (574) 256-5001 MODEL 578-24 MagnaValve 578-24data.pub 5/18/09 SPECIFICATIONS Sensor Display LED’s: Val

Nessun commento

Electronics 578-24 Manuale Utente